Automobile Accessories User Manual

13. Measure and mark the upper steering column

cover.

16. Locate the 2-pin connector included in the kit, and

lower the lock. Firmly push the LED terminals into

the 2-pin connector.

14. While wearing eye protection, lightly center-punch

the mark; then drill a 5.5 mm hole through the

upper steering column cover. Remove all burrs.

15. Route the terminal ends of the LED through the

hole you just drilled, and secure the LED with the

push nut. Install the push nut securely.

17. Measure and mark the driver's dashboard lower

cover. (If necessary, remove the insulation.)

18. While wearing eye protection, lightly center-punch

the mark; then drill a 12 mm hole through the

center-punched mark.

• First drill a pilot hole with a 10 mm bit, then

finish with a 12 mm bit.

• Remove all burrs.

UPPER STEERING

COLUMN COVER

5.5 mm

DRILL

MARK

20 mm

Insert.

Lock.

WHITE WIRE

RED WIRE

First drill with a

10 mm bit, then with

a 12 mm drill bit.

15 mm

BACK OF

DRIVER'S

DASHBOARD

LOWER COVER

MARK

25 mm

UPPER STEERING

COLUMN COVER

LED

PUSH NUT