Automobile Accessories User Manual

© 2000 American Honda Motor Co., Inc - All Rights Reserved. All 21624 (0008) 7 of 12
19. Route the terminal ends of the disarm switch
through the hole you just drilled, and secure it with
the washer and 12 mm nut from the kit.
20. Locate the 3-pin connector included in the kit.
Firmly push the disarm switch terminals into the
3-pin connector until they click into position, and
lower the lock. Slide the white connector clip onto
the underside of the 3-pin connector.
NUT
WASHER
DISARM SWITCH
DRIVER'S
DASHBOARD LOWER
COVER
21. Push the wire tie with clip into the hole in the back
of the control unit bracket. Position the control unit
bracket on the driver's dashboard lower cover, and
install the three self-tapping screws from the
attachment kit.
22. Position the control unit on the control unit bracket,
and install the two 4 x 30 mm washer-screws.
Secure the antenna to the control unit bracket with
the wire tie with clip you just installed, as shown.
Secure the antenna parallel with the control unit.
CONTROL
UNIT
BRACKET
BACK OF DRIVER'S
DASHBOARD
LOWER COVER
WIRE TIE
WITH CLIP
SELF-TAPPING
SCREW
ANTENNA
WIRE TIE WITH CLIP
CONTROL UNIT
BRACKET
CONTROL
UNIT
4 x 30 mm
WASHER-SCREW
3-PIN
CONNECTOR
WHITE
CONNECTOR
CLIP
BLUE WIRE
BLACK WIRE
Insert.
Lock.