Automobile Accessories User Manual

8 of 12 All 21624 (0008) © 2000 American Honda Motor Co., Inc - All Rights Reserved.
23. Secure the disarm switch wire harness to the
disarm switch with one short wire tie, then attach
the harness to the driver's dashboard lower cover
with two halves of a cushion tape in the areas
shown. (Cut a cushion tape in half with scissors,
and use the two halves to secure the harness.)
24. Push the clip on the 3-pin connector of the disarm
switch into the hole in the control unit bracket.
25. From the driver's side, route the 14-pin connectors
of the security system wire harness to the left fuse
box. Unplug the 14-pin connector from the fuse
box, and plug the 14-pin connectors of the security
system wire harness in between.
26. Attach the 14-pin connector of the security system
wire harness to the side of the vehicle connector.
SECURITY SYSTEM
WIRE HARNESS
14-PIN CONNECTOR
LEFT FUSE BOX
VEHICLE
CONNECTOR
27. Locate the two 2-pin connectors blue-taped to the
vehicle harness, and remove the blue tapes to free
the connectors. Plug the 2-pin connectors you just
freed into the 2-pin connectors of the security
system wire harness. Connect the blue 2-pin
connector of the vehicle harness to the blue 2-pin
connector of the security system wire harness.
DISARM SWITCH
SHORT
WIRE TIE
CUSHION TAPE
(Cut in half.)
CONNECTOR
CLIP
CONTROL
UNIT
BRACKET
LEFT FUSE
BOX
SECURITY SYSTEM
WIRE HARNESS
14-PIN CONNECTORS
(SECURITY SYSTEM
WIRE HARNESS)
14-PIN CONNECTOR
(VEHICLE HARNESS)
SECURITY
SYSTEM
WIRE
HARNESS
LEFT FUSE BOX
2-PIN
CONNECTORS
(GRAY)
2-PIN
CONNECTORS
(BLUE)