user manual

−
−
−
101
SUBMERGED OUTBOARD
MOTOR
WATER SEPARATOR
INDICATOR
Digital Speedometer
TAKING CARE OF UNEXPECTED PROBLEMS
Change the engine oil and oil filter
as described on p. . If
there was water in the engine
crankcase, or if the used engine oil
showed signs of water
contamination, then a second
engine oil change should be
performed after running the engine
for half an hour.
Remove the spark plugs (p. ).
Operate the starter to expel water
from the engine’s cylinder.
When the water separator indicator
blinks:
Check the water separator for water
contamination. If water is present,
stop the engine, and clean the water
separator following the instructions
on pages , or consult with
an authorized Honda Marine dealer.
Drain the vapor separator as
described on p. .
Remove the engine cover, and
rinse the outboard motor with
fresh water to remove salt water,
sand, mud, etc.
If there is a Honda Marine dealership
nearby, take the outboard motor to
the dealer immediately. If you are far
from a dealership, proceed as
follows:
A submerged outboard motor must
be serviced immediately after it is
recovered from the water in order to
minimize corrosion.
1.
2.
3.
4.
Normal
Abnormal
65 67
70
77 78
85 86
11/03/17 10:49:59 31ZY2630_102