user manual

36
Anodes Fuel Priming BulbRev Limiter
CONTROLS AND FEATURES
ANODE
(each side)
ANODE
(stern bracket)
PRIMING BULB
UP
INLET END (tank side)
OUTLET END
(outboard motor side)
The anodes are made of a sacrificial
material that helps to protect the
outboard motor from corrosion.
Before starting the engine, hold the
priming bulb up in the direction of
the arrow; then squeeze the priming
bulb until it feels firm. This will
ensure that fuel is supplied to the
engine (p. ).
A priming bulb is built into the fuel
hose that connects the fuel tank to the
outboard motor.
There are two anodes on the gear
case, one on the stern bracket and
four small anodes in the water
passages of the engine block.
The engine is equipped with a rev
limiter to prevent the possibility of
mechanical damage from excessive
engine speed.
The rev limiter may be activated
during operation, limiting engine
speed, if the outboard motor is
trimmed or tilted up excessively, or
when propeller ventilation occurs
during a sharp turn.
If the rev limiter is activated, check
the trim angle of the outboard motor.
Check to see if the correct propeller
is installed.
40
11/03/17 10:38:04 31ZY2630_037