user manual

48
OPERATION
N (neutral)
CONTROL
LEVER
FAST IDLE BUTTON
If the engine is not properly
warmed up before raising the
engine speed, the buzzer and
overheat indicator may activate
and the engine speed will be
automatically reduced.
The cooling system may f reeze in
areas where the temperature
reaches 32°F (0°C) or below.
Cruising at high speed without
warming the engine up may cause
engine damage.
Turning the ignition switch key to
the START position while the
engine is running can damage the
starter motor and f lywheel.
Using the electric starter f or more
than 5 seconds at a time will
overheat the starter motor and can
damage it.
Before getting underway, allow
the engine to warm-up sufficiently
to ensure good performance.
Above 41°F (5°C), warm-up the
engine for 2 or 3 minutes.
Below 41°F (5°C), warm-up the
engine for at least 10 minutes at
2,000 rpm. Push the fast idle
button, and then move the control
lever forward or reverse to open
the throttle and achieve
approximately 2,000 rpm.
If the engine fails to start within 5
seconds, release the key and wait
at least 10 seconds before
operating the starter again.
5.
11/03/17 10:40:13 31ZY2630_049