user manual

‘‘ ’’
2.5 lbf·ft (3.4 N·m , 0.35 kgf·m)
78
SERVICING YOUR OUTBOARD MOTOR
‘‘I’’ MARK
WATER SEPARATOR
SUSPENSION
STRAP
SUSPENSION STRAPBOWL
O-RING
CUP
SUSPENSION STRAP
FUEL HOSES
SEPARATOR ASSEMBLY
SCREW(3)
Pinch the fuel hoses with
commercially available hose clips
to prevent fuel leakage.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
If the buzzer sounds or water or
sediment accumulation are found to
be caused by excessive water or
sediment accumulation in the fuel
filter, inspect the fuel tank.
Squeeze and release the priming
bulb to fill the vapor separator, and
check for leaks.
Remove the three screws and
separate the water separator cup
from the body.
Thoroughly clean the water
separator cup.
Reassemble the water separator
body and the cup.
TIGHTENING TORQUE:
Alignthe I markonthe
suspension strap as shown above
and install the water separator to
the bracket.
Remove the suspension strap from
the water separator bracket; then
remove the strap from the
separator assembly.
During removal of the separator
assembly, take care not to damage
the wire harness with the separator
bracket. 7.
6.
5.
4.
3.
8.
9.
11/03/17 10:45:43 31ZY2630_079