Outboard Motor User Manual

8.0 US qt (7.6 L)
8.2 US qt (7.8 L)
66
Oil Filter Change
SERVICING YOUR OUTBOARD MOTOR
SEALING WASHER
DRAIN BOLT COVER
DRAIN BOLT
OIL DRAIN
GUIDE
Improper disposal of engine oil
can be harmf ul to the environment.
If you change your own oil, please
dispose of the used oil properly.
Put it in a sealed container, and
take it to a recycling center. Do
not throw it in the trash, pour it on
the ground or down a drain.
Install and lock the engine cover.
With the outboard motor in a
vertical position, fill to the upper
limit mark on the dipstick (p. )
with the recommended oil.
Engine oil refill capacity:
Without oil filter change:
With oil filter change:
Install the oil filler cap and tighten
it securely.
Set the drain bolt cover under the
guide.
Install the drain bolt cover and
secure it with the screw.
Drain the engine oil, and reinstall
the drain bolt washer, and oil drain
bolt cover (see Engine Oil Change
on p. ).
Use a suitable tool to remove the
oil filter, and thoroughly drain the
filter into the used oil container.
Tilt the outboard motor, and place
a suitable container below the oil
drain guide to catch the used oil.
Place a suitable container below
the oil drain guide to catch the
used oil, and then remove the oil
filler cap, drain bolt, and sealing
washer.
Allow the used oil to drain
completely. Use a new sealing
washer, and then reinstall the
engine oil drain bolt and washer.
Tighten the drain bolt securely.
3.
1.
2.
3.
6.
7.
8.
9.
4.
5.
65
65
11/03/17 10:43:40 31ZY2630_067