Product Manual

10 ENGLISH
6 : 1 Reduction Case
1. Remove the oil-level-check bolt
and washer, and see whether
the oil level is at the edge of the
bolt hole.
2. If the oil level is below the check
bolt hole, remove the filler bolt
and washer. Add oil until it starts
to flow out the check bolt hole
with the recommended oil (see
page 9).
3. Install the oil-level-check bolt,
filler bolt and washers. Tighten
them securely.
Oil Change
2 : 1 Reduction Case With Centrifugal Clutch
Drain the used oil while the engine is warm. Warm oil drains quickly
and completely.
1. Place a suitable container below the reduction case to catch the
used oil, then remove the oil filler cap/dipstick, drain plug and
washer.
2. Allow the used oil to drain completely, then reinstall the drain
plug and a new washer, and tighten the plug securely.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash or pour it on the ground
or pour it down a drain.
3. With the engine in a level position, fill with the recommended oil
(see page 9) to the upper limit mark on the dipstick. To check
the oil level, insert and remove the dipstick without screwing it
into the filler hole.
Reduction case oil capacity: 0.50 L (0.53 US qt, 0.44 lmp qt)
Running the engine with a low reduction case oil level can cause
reduction case damage.
4. Screw in the filler cap/dipstick securely.
Wash your hands with soap and water after handling used oil.
OIL-LEVEL-CHECK BOLT
OIL LEVEL
FILLER BOLT
LOWER LIMIT
DRAIN PLUG
FILLER CAP/DIPSTICK
UPPER
LIMIT
6 : 1 Reduction Case
Drain the used oil while the engine is warm. Warm oil drains quickly
and completely.
1. Place a suitable container below the reduction case to catch the
used oil, then remove the filler bolt, oil-level-check bolt and
washers.
2. Drain the used oil completely into the container by tipping the
engine toward the oil-level-check bolt hole.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash or pour it on the ground
or pour it down a drain.
3. With the engine in a level position, fill with the recommended oil
(see page 9) until it starts to flow out the check bolt hole.
Running the engine with a low reduction case oil level can cause
reduction case damage.
4. Reinstall the oil-level-check bolt, filler bolt and new washers,
and tighten them securely.
Wash your hands with soap and water after handling used oil.
AIR CLEANER
A dirty air cleaner will restrict air flow to the carburetor, reducing
engine performance. If you operate the engine in very dusty areas,
clean the air filter more often than specified in the MAINTENANCE
SCHEDULE.
Operating the engine without an air filter, or with a damaged air
filter, will allow dirt to enter the engine, causing rapid engine wear.
This type of damage is not covered by the Distributor’s Limited
Warranty.
Inspection
Remove the air cleaner cover and inspect the filter elements.
Clean or replace dirty filter elements. Always replace damaged filter
elements. If equipped with an oil-bath air cleaner, also check the oil
level.
Refer to pages 11–12 for instructions that apply to the air cleaner
and filter for your engine type.
FILLER BOLT
OIL LEVEL
OIL-LEVEL-CHECK BOLT
32Z4HA00.fm 10 ページ ２０１２年７月１１日 水曜日 午前１０時３分