User Manual

6.
BF75NBF90A
Shaft
Length
INSTALLATION HEIGHT
RECOMMENDATIONS
Out board Workable Boat
Transom Height Transom Height
Description
Transom Mount Drill Fixture
TRA
N
S
0
M D RI L LI
N
G
See also “USING THE TRANSOM MOUNT DRILL
FIXTURE” on page 1-23.
Part
No.
07MPZ-ZV301
OC
The BF75A and BF9OA outboards motors are
designed to be installed on a boat transom with the
following transom board thickness:
I
Boat Transom Board Thickness
1
I
50
- 70 mm (2 - 2.75 in) ~~
1
1. Set the outboard motor onto the boat transom
and verify the installation height is correct.
Unit:
mm
(in)
e
X
0
?
Lo=
c)
=
In
TRANSOM
TOARD
TOP
Ing
I
251
;i
In=
N
0
TRANSOM
DRILL
FIXTURE
@
D
C
B
0
D
C
Use the
upper
“C”
and
lower
“D”
holes.
2. Mark four center marks for the bolt holes on the
transom board (two marks on either side of the
outboard motor installation lines).
The upper bolt holes should be more than
33 mm (1.3 in) from the top of the transom.
The lower bolt holes should allow the mounting
bolts to contact the upper end of the stern
bracket.
4
90”
3. Drill four holes with a 17/32 drill bit.
Date
of
Issue: June
2003
0
2001-2003
American Honda Motor
Co.,
Inc.
615