User Manual

6. BF75NBF90A
TILLER HANDLE ASSEMBLY
INSTALLATION
1. Remove right side cap from tilt tube.
FRICTION SHAFT
FRICTION BLOCK
FRICTION BOLT
COTTER PIN
2. Apply marine grease to the friction shaft and
install friction shaft into tilt tube.
Apply marine grease to O-ring then install
0-
ring into friction block.
Install friction block over friction shaft and onto
tilt tube.
Install the friction bolt,
6 mm nut, and cotter pin
on the friction block.
SCREW, 5 x 12 rnrn
METER WIRE HARNESS A
POWER TRlMRlLT MOTOR WIRE
TRIM ANGLE SENSOR WIRE
METER WIRE HARNESS A
Make a U-shape turn as
shown. After connecting the connectors,
HARNESS BAND
clamp them with the harness
band as shown.
3. Connect Meter Wire Harness A to the tiller
handle wire harness.
Remove tiller handle cover, and connect
Meter Wire Harness A to tiller handle
harness.
Connect harnesses as shown and secure
with harness bands and harness clips.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
618