User Manual

7. BF115AIBF130A
INSTALLATION HEIGHT
RECOMMENDATIONS
Shaft I Outboard I WorkableBoat I
Length I Transom Height I Transom Height I
TRANSOM DRILLING
See also ‘USING THE TRANSOM MOUNT DRILL
FIXTURE” on page 1-23.
I Description I PartNo. I
I Transom Mount Drill Fixture I 07MPZ-ZV3010C I
The BF115A and BF130A outboards motors are
designed to be installed
on a boat transom with the
following transom board thickness:
Boat Transom Board Thickness
50 - 70 mm (2 - 2.75 in)
1. Set the outboard motor onto the boat transom
and verify the installation height is correct.
Unit: mm (in)
d
X
Fi -
k L“=
In TRANSOM BOARD TOP
0 Be
TRANSOM DRILL FIXTURE
@
D
C
BB
0
Use the upper “C” and lower “D” holes.
2. Mark four center marks for the bolt holes on the
transom board
(two marks on either side of the
outboard motor installation lines).
The upper bolt holes should be more than
33 mm (1.3 in) from the top of the transom.
The lower bolt holes should allow the mounting
bolts to contact the upper end
of the stem
bracket.
3. Drill four holes using a 17/32 drill bit.
7-7
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.