User Manual

7. BF115AIBF130A
REMOTE CONTROL CABLE
INSTALLATION AND ADJUSTMENT
Route and connect cables to the remote control
before connecting them to the motor.
THROTTLE SHIFT
CABLE
BATTERY
CABLE
WIRE HARNES
viewed from outside
GROMMET
-E TIE
1.
2.
WHITE
MARK
Pass the main wire harness, indicator wire
harness, battery cable and control cables
through grommet.
Make sure the white mark on the battery cable
aligns with the inside edge of the grommet.
Position the cable tie on the switch panel wire
harness and the indicator wire harness at the
inside
of the grommet.
CONTROL CABLE PLATE
THROTTLE CABLE \SHIFT CABLE
3. Install the remote control cable plate by aligning
groove in control cables and groove in
undercase.
SEPARATE COVER FLANGE BOLT,
HEX. BOLT, 6 x 40 mm
edgekide against
Dainted surface.
BOAT
I
4. Install separate cover and tighten bolts
securely.
TORQUE:
Flange bolt, 6 x 30 mm; 12 N-m (9 ft-lb)
Hex bolt,
6 x 40 mm; 10 N*m (7 ft-lb)
INDICATOR PANEL
WIRE HARNESS
MAIN WIRE HARNESS
ENGINE WIRE
HARNESSES
5. Connect the indicator panel wire harness and
switch panel or main wire harness to the engine
wire harnesses. Attach the harness connectors
to the holder and secure wire harnesses to
harness clip.
711 0
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co.. Inc.