User Manual

7. BFIlSA/BF130A
THROTTLE CABLE CONNECTION
1. Put the remote control lever in the NEUTRAL
position.
2.
3.
THROTTLE CABLES
CLOSE OPEN
4. Move the remote control lever to the full throttle
position. Make sure the throttle arm contacts the
throttle arm stopper. If the throttle am does not
contract throttle arm stop, check for full stroke at
the remote control.
Avoid changing the open or close throttle cable
adjustment. These cables normally do not
require adjustment during predelivery service.
If these cables are changed unnecessarily, full
Thread the pivot shaft onto the threaded portion
of the throttle cable. Apply marine grease to the
pivot pin.
Adjust the pivot shaft until
it slips into the throttle
arm. Install the pivot shaft from the engine side.
Install washers on both sides of the arm and
secure with a lock pin.
throttle and/or idle speed June be adversely
affected. If you cannot achieve full throttle or
proper idle speed, always check control cable
adjustment first before changing the open
or
close throttle cable adjustment or idle rpm. See
Honda Marine BFllSA/BF130A Shop Manual,
page 3-10 through 3-13, for cable adjustment.
74 1
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.