User Manual

8. BF2OONBF225A
STEERING
SELECTION
A single cable steering system is not recommended
for either the BF200A or BF225A.
The steering system selection is determined by the
particular application. Consult the boat
manufacturer or steering manufacturer for
recommendations.
Hydraulic steering would be the best choice to
improve boat stability, minimize
lost motion in the
steering system, and reduce boat chine walk on
high-performance boats. Dual cables can also be
considered.
A good steering system will help to
eliminate steering free play which June cause the
outboard motor to move side-to-side slightly at high
speeds resulting in chine walk. For further
information regarding hydraulic steering or dual
cable steering, refer to the hydraulic steering,
mechanical steering or dual cable kit
manufacturer’s instructions.
STEERING PREPARATION
CAP rn
\I
\I
In1 I
\I IUI 1
Remove the cap from the steeringhlt tube prior to
installing the steering system.
Loosely install the hydraulic or mechanical steering
cables on the motor before final placement
of the
motor on the transom.
Refer to the steering cable or hydraulic steering
manufacturer’s instruction manual for handling
procedures.
STEERING LINK ARM INSTALLATION
BOLT
(discard)
I
(discard)
FIBER WASHER &?-
(discard)
SThNLESS BOLT 1/4-28 (2) NUT
(reinstall and tighten) (discard)
Remove the bolts and bracket from the steering
arm. Discard the hardware indicated and reinstall
the 1/4-28 bolts.
Steering Link Arm
P/N 06532-ZY3-UOO
(optional part, includes all hardware)
\
819
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.