User Manual

8. BF200AIBF225A
REMOTE CONTROL CABLE
INSTALLATION AND ADJUSTMENT
Route the electrical harnesses and cables through
the boat. Connect the cables to remote control
before connecting them to the motor.
WHITE TAPE
/ CABLE
FRONT COVER
REMOTE CONTROL
CABLE
PLATE
5. Install the remote control cable plate with the
6
x 16 mm hex bolt.
BRACKET
1. Route the battery cable to the front cover
bracket. Position the battery cable white tape
mark
so it aligns with the edge of the front cover
bracket.
2. Spray the grommet with silicone spray.
Viewed from outside
REMOTE CONTROL
CABLE (Throttle control)
INDICATOR PANEL
REMOTE
CONTROL CABLE
3.
/ WATER PRESSURE HOSE
[(optional
part) puncture rubber
BATTERY
CABLE membrane]
Run the fuel hose, indicator wire harness,
battery cable and main harness through the
undercase grommet
A.
GROMMET A
FRONT~OVER I \
BRACKET GROOVE
4. Install the grommet by aligning it with the groove
in the front cover bracket.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
811 2