User Manual

8. BF200NBF225A
ENGINE
ELECTRICAL
MAIN WIRE HARNESS
LOOP
6.
7.
Connect the indicator panel
3 pin and main 14
pin connectors to the engine electrical bracket.
Secure the connectors to the locking tabs on
the bracket. Route the wires through the locking
plastic loop and follow the path to the grommet.
Route the
two individual portions of the harness
through the grommet as indicated.
Loosen the control cable lock nuts
approximately
1/2 inch from the end of the
cable. Thread the cable ends onto the cables
with a minimum of
1/2 inch thread engagement
as a starting point for adjustment.
Do not tighten
the lock nuts at this time.
With the remote control lever in the NEUTRAL
position, the shorter cable will always be the
throttle cable.
UNDERCASE
GROMMET A
8. Install the control cables with the throttle cable
inside and the shift cable outside. Install the
clamp (included with engine) on the undercase
grommet
A or slip a 50 mm (2 in) corrugated
flexible hose over the undercase grommet
A
and secure the corrugated flexible hose (not
included) with the clamp.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
811 3