User Manual

1. COMMON MODEL INFORMATION
New Tie Bar Installation
TWIN ENGINES
Installat ion Instruct ions:
New Style Tie Bar
following formulas below:
The CD dimension must include allowance for engine
toe in/out as required, or recommended
by the engine
manufacturer. Failing to observe toe in/out recommendations may
result in harder than normal steering effort.
threaded rod must always fully cover inspection hole 1 of the rod
end, but never inspection hole
2. Failing to observe this warning
may result In one engine becoming separated from the steering
system resulting in property damage and/or personal injury.
The SeaStar tie bar is designed
for use on Teleflex/SeaStar
cylinders only.
it may not be compatible with other cylinders.
Note: Maximum standard engine center- 3ft. (0.9m)
Note: H06001 Minimum Engine centers= 26" (660mm)
H06001
Note: Engine or tiller centers=CD
X=CD
- 14%" (375rnm)
Y=CD - 18%" (464mm)
INSPECTION HOLES
I
I - TUBE LENGTH Y I i
b- THREADED ROD LENGTH = X
Note: Johnson/Evinrude 200-225HP (1991 To Date) and
Johnson/Evinrude flCHT 90-225HP (1996
To Date)
H06002 Minimum Engine centers
= 29" (737mm)
H06002
X=CD - 19%'' (489mm)
Y=CD - 22%" (572mm)
All other makes and models
H06002 Minimum Engine centers
= 27" (685mm)
INSPECTION HOLES
Enwn YO" -l/4" MP to allow r&ad b.ll loM to mtata.
INSPECTION
Note: H06003 Minimum Engine centers= 26" (660mm)
H06003 HOLES
X=CD - 10%" (257rnrn)
Y=CD - 13%" (340mm)
" ~ ~uunYW-I/4"MPtoemw2 ro+.ndb.ll~toro(.t..
piston stop. The tle-bar may have to be disconnected.
Failure to do
so may fail to purge ail the air from the system,
causing poor performance.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
1130