User Manual

9. GAUGES
WATER PRESSURE GAUGE RUBBER HOSE INSTALLATION
1.
2.
After installing the speedometer in the dash,
connect the rubber hose to the back of the
speedometer and secure with a cable tie.
Route the rubber hose back to the motor
alongside the control cables.
A slight downward slope from bow to
stern will help avoid trapping water.
Avoid sharp turns, crimping, kinking, or
other forces that June reduce the inside
diameter
of the hose.
Do not coil any excess rubber hose.
Carefully measure, then cut to the desired
length.
BF75/90/115/130
1. Remove the grommet and make a hole a little
larger than the rubber tubing.
2. Route the tubing through the grommet and
reinstall the grommet.
3.
4.
5.
Remove the flush valve
spacer.
Drill and tap the flush valve
spacer raised bossed to
1/8"
N PT.
Thoroughly clean the flush
valve spacer then reinstall it.
FLUSH VALVE SPACER
BF115/130
FLUSH VALVE SPACER II
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
94 8