User Manual
Table Of Contents
9.
GAUGES
Ref
1
2
3
4
5
6
7
Water Pressure Gauge (not included in 5 gauge set)
Qty.
Description
1
Water Pressure Gauge
1
Mounting Bracket
I
RubberHose
2 BrassNut
2
Star Washer
1
1/8" NPT Fitting
1
RedSleeve
08
8
9
2 CableTie
118" BSPT (British Pipe Thread-
118"
NPTF (National Pipe Thread-
1
male) female)
AdaDtor 1/8" NPTF To BSPT
Analog Hour Meter (not included in 5 gauge set)
Ref
1
Qty
Description
1 Volt Meter
Mounting Bracket
4
2 BrassNut
Speedometer
Tachometer
Trim Meter
Volt
Meter
Fuel Gauge
Water Pressure
0
86
mm
(3-3/87
86
mm
(3-3/8")
52.4
mm
(2-1/16")
52.4
mm
(2-1/16")
52.4
mm
(2-1/16")
52.4
mm
(2-1/16")
Use the Beede Instrument Harness (P/N 32103-ZW7-000AH~ to connect Beede gauges to the Honda main harness
(refer to 9-25).
GAUGE INSTALLATION
1.
Disconnect the negative battery terminal cable.
2.
Select a mounting location for the appropriate gauge(s) which
provides easy readability from the operator's position. Check
behind each mounting hole location for sufficient installation
clearance.
3.
Cut a hole
in
the dash
for
each gauge to the specification shown.
4.
Install the gauge in its mounting hole and check the fit.
If necessary, install the red cover over the light bulb before
installing the gauges:
a. Twist the black socket assembly one-eighth turn
counterclockwise and remove it.
b. Pull the bulb straight out of the assembly.
c. Slip the red sleeve over the bulb and install socket assembly.
4.
Mount the gauges with the appropriate mounting bracket, star
washers and brass nuts as shown starting on the next page.
Tighten the nuts until the gauge can no longer be rotated in the
dash.
I
,-
Hour Meter
I
52.4
mm
(2-1116")
LIGHT SOCKET
If necessary, shorten the clamp legs if the dashboard thickness exceeds clamp grip range.
Do
not overtighten the mounting nuts. Overtightening the nuts June crack the gauge housing, mounting
bracket
or
mounting panel.
9123
Date
of
Issue: June
2003
0
2001-2003
American Honda Motor
Co.,
Inc.