User Manual

9. GAUGES
WATER PRESSURE GAUGE TUBING INSTALLATION
1. After installing the water pressure gauge in
the dash, connect the rubber hose to the
back
of the water pressure gauge and
secure with a cable tie.
2. Route the rubber hose back to the motor
alongside the control cables.
Avoid sharp turns, crimping, kinking, or
other forces that June reduce the inside
diameter
of the hose.
Do not coil any excess hose. Cut hose to
the desired length.
3. Fasten the rubber hose at regular intervals
with small plastic cable ties (be careful to
not pinch the hose).
NIPPLE
BF7519011151130 GROMMET
1. Remove the grommet and make a hole a little
larger than the rubber hose.
2. Route the rubber hose through the grommet
and reinstall the grommet.
3. Remove the flush valve
spacer.
4. Drill and tap the flush valve
spacer raised bossed to
1/8"
N
PT.
valve spacer then reinstall it.
5. Thoroughly clean the flush
BF75/90
FLUSH VALVE SPACER
BFll5/130
I1/8" NPT I
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
9130