User Manual

9. GAUGES
BF2001225
1. Use a 5 mm hex wrench and remove the
water pressure access plug (located above
the starboard exhaust manifold).
2. Apply sealing compound to the adaptor
1/8
NPTF to BSPT (supplied with kit*) and
install the adaptor securely where the access
plug was removed.
3. Apply sealing compound to the 1/8
NPT
brass hose fitting (supplied with kit) and
install the fitting securely in the adaptor.
4. Use a 7/32" drill bit and open the hole
through the grommet membrane.
ADAPTOR 118" NPTF TO BSPT*
I
118" NPT
FITTING
CABLE ?lE
RUBBER
HOSE
5. Route the rubber hose through the hole and to the hose fitting.
6. Attach the hose to the brass fitting and secure it with a cable tie.
7. Use cable ties and secure the rubber hose to various spots on the motor making sure it does not come
into contact with any moving parts or hot components.
*Some water pressure gauge kits will not have the adaptor supplied.
Do not use the 1/8" NPTF adaptor.
Order
P/N 19271-ZV5-000 BSPT 1/8 hose barb fitting.
LIGHT BULB REPLACEMENT
1. Twist the black socket assembly one-eighth turn
counterclockwise and remove it.
2. Pull the bulb straight out of the assembly.
REPLACEMENT BULBS: GE161
red sleeve and install
it on the new bulb before
reinstalling the socket assembly.
3.
If a red sleeve is covering the meter bulb, remove the
RED SLEEVE
T
4. Reinstall the socket assembly.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.