User Manual

9. GAUGES
1.
2.
3.
4.
5.
6.
7.
8.
9.
~~
CABLE
TIE
SPEEDOMETER RUBBER HOSE INSTALLATION
After installing the speedometer in the dash, connect the
rubber hose to the back of the speedometer and secure with a
cable tie.
Route the rubber hose back to the motor alongside the control
cables.
A slight downward slope from bow to stern will help avoid
trapping water.
Avoid sharp turns, crimping, kinking, or other forces that
June reduce the inside diameter of the hose.
Do not coil any excess rubber hose. Carefully measure, then
cut to the desired length.
Fasten the rubber hose at regular intervals with
small plastic wire ties (be careful not to pinch
tubing).
Starting at the top of the swivel case, route the
rubber hose over the top of the steering arm,
down through the inside
of the swivel case
alongside the shift rod, and out the bottom of the
swivel case to the pitot tube.
Cut approximately
3 mm (1/8”) off the
nipple end.
RUBBER HOSE
..
RUBBER HOSE
Clean the pitot tube if it is clogged with
salt or any other foreign material.
Cut the hose to the appropriate length to
reach the nipple end.
Press the end of the hose over the nipple
and secure with
a cable tie.
Gently feed the pitot tube and rubber
hose back
up through the swivel case
until a slight loop is made in the pitot tube.
Secure the hose to the steering arm with
cable ties.
CUT ABOUT 3 mm (1/8”)
9139
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.