User Manual

BF200/225
1.
2.
3.
4.
Use a 5 mrn hex wrench and remove the
the starboard exhaust manifold).
Apply sealing compound to the adaptor
1/8" NPTF to BSPT (supplied with kit*) and
install the adaptor securely where the
access plug was removed.
Apply sealing compound to the 1/8" NPT
brass hose fitting (supplied with kit) and
install the fitting securely in the adaptor.
Use a 7/32" drill bit and open the hole
through the grommet membrane.
water pressure access plug (located above
ADAPTOR 1/8" NPTF TO BSPT*
I
MEMBRANE
CABLE
TIE
RUBBER
HOSE
5. Route the rubber hose through the hole and to the hose fitting.
6. Secure the hose to the brass fitting with a cable tie.
7. Use cable ties and secure the rubber hose to various spots on the motor making sure the hose does not
come into contact with any moving parts or hot components.
*Some water pressure gauge kits will not have the adaptor supplied.
Do not use the 118" NPTF adaptor.
Order P/N 19271-ZV5-000 BSPT 118" hose barb fitting.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.