User Manual

10. CONTROL BOXES AND TEMPLATES
COMPONENT IDENTIFICATION
This section shows the right-hand handle type only. The right-hand remote control is designed to perform
the throttle operation and the tilt angle adjustment with the right hand. Note the name and operation of each
part of the left-hand handle type are identical with those of the right-hand handle type.
Top Mount Remote Control (right-hand handle type shown)
Single Top-Mount Remote Control Dual Top-Mount Remote Control
POWER TRlM/TlLT SWITCH
(one per engine)
E
OL
FAST IDLE BUTTON
(one on each side)
Remote Control Lever
Power Trim/Power Tilt
The remote control lever controls gear selection and throttle opening
positions.
For power trim: Press the power trim/tilt switch on the remote control lever to
adjust the motor trim angle to maintain proper boat trim.
For power tilt: Press the power trimhilt switch on the remote control lever to
adjust the motor tilt angle.
Fast Idle Button
Used for engine starting and warm-up. With the fast idle button pushed in, the
remote control lever can be moved forward or backward. This opens and
closes the throttle without engaging the propeller.
Spacer (0 pt io na I)
For single lever type
(PIN 06241-ZWI-UOO)
For dual lever type
(PIN 06241 -2WI-UIO)
The spacer is not included in the remote control kit. It is available as an optional part. Purchase a genuine
Honda spacer for the outboard motor remote control kit as needed.
The installation height of the remote control increases 25 mm (0.98 in) by mounting the spacer.
Check the spacer installation position and the surrounding area for freedom from interference and
restriction.
104 0
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.