User Manual
Table Of Contents
10.
CONTROL BOXES AND TEMPLATES
INSTALLATION POSITION
Select the remote control installation position on the
boat.
50
mm (1.97 in)
minimum
Do
not bend the
cables and
harnesses sharply.
Route the cables1
harnesses with the
bending radius
of
wheel, etc.).
K
406 more.
mm
(16.0 in) or
Obtain adequate space
between the
bottom
of
the
remote control and the
surrounding parts so that the
remote control does not
interfere with any of the
surrounding parts (steering
I
Install the remote control in the position that allows
proper remote control lever operation, and where
the cables and harnesses can be routed properly
without strain between the remote control and the
outboard motor.
Recommended Installation Position
138 mm
(5.43
in)
I
(2.95
in)
(5
in)
(6.37 in)
The above illustration details the space necessary
to install the remote control.
LEFT-HAND HANDLE RIGHT-HAND HANDLE
SINGLE LEVER TYPE
SINGLE LEVER TYPE
Both the single and the dual lever type remote
controls are available in the right-hand handle
type and the left-hand handle type respectively.
Select the correct type for the boat.
TOP MOUNT INSTALLATION
(right-hand handle, single lever type)
This section explains the installation procedure
of
the right-hand handle, single lever type remote
control. The left-hand handle, single lever type
remote control and the left-handlright-hand handle,
dual lever type remote controls can be installed in
the same manner.
1.
Attach the drilling template (included in kit) to
the remote control mounting surface using
adhesive tape.
2.
Drill the installation holes and cut out the center.
3.
Install the control cushion around the opening
and spacer (if used).
4.
Pass the remote control wire harness and the
control cables along the route properly.
5.
Remove the cover and the other parts as
shown.
Date
of
Issue: June 2003
0
2001-2003 American Honda Motor
Co.,
Inc.
I04
2