User Manual

10. CONTROL BOXES AND TEMPLATES
HOUSING LEA
CONTROL CUSHION-
SCREWS
BACK PLATE
INNER HOUSIN
6. Remove the screws and remove the back plate
from the inner housing.
7. Apply marine grease to both the shift and
throttle pins at the end of each arm.
CONTROL CABLE
CABLE CLAMP
SPACER
8. Install the gearshift control cable groove in the
housing clamp groove. Insert the cable end over
the pin at the end
of the shift arm and secure
with an E-ring.
9. Insert cable clamp spacer in clamp groove.
10. Apply marine grease to the throttle cable pin
where it connects to the throttle arm.
I1
11. Connect the throttle control cable to the throttle
arm, in the same manner as the gearshift
control cable, with an E-ring.
12. Install the back plate and the housing bracket in
the reverse order
of removal.
/-----7
WASHER
WASHER
NUT
104 3
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.