User Manual

10. CONTROL BOXES AND TEMPLATES
COMPONENT IDENTIFICATION
NEUTRAL RELEASE LEVER
POWER TRlM/TlLT SWITCH
CONTROL LEVER
OIL PRESSURE INDICATOR LIGHT
OVERHEAT INDICATOR LIGHT
CHOKElFAST IDLE LEVER
IGNITION SWITCH
EMERGENCY ENGINE
STOP SWITCH
Neutral Release Lever
Power Trimmilt Switch
Control Lever
Indicator Lights
Choke/Fast Idle Lever
Ignition Switch
Emergency Engine Stop
Switch
Friction Adjuster
Operation
‘FRICTION ADJUSTER
Must be raised to move the control lever into forward or reverse gears.
Adjusts the trim angle and operates tilt UP and DOWN.
Controls gear selection and throttle opening.
Indicates engine oil pressure and cooling system conditions.
Operates the throttle and choke when the control lever is in neutral.
For starting and stopping the outboard motor.
With the lanyard securely attached to the operator and if the operator is thrown
from his seat or out of the boat, the lanyard is pulled disengaging the stop switch
clip from the stop switch to stop the engine.
Adjusts the operating resistance of the control lever.
CHOKE RANGE
Start the engine with the control lever in
the NEUTRAL position. For cold starts,
the choke/fast idle lever should be fully
raised, then lowered slowly to avoid
stalling.
The choke/fast idle lever cannot be raised
unless the control lever is in the
NEUTRAL position, and the control lever
cannot be moved away from NEUTRAL
unless the choke/fast idle lever is
lowered.
With the choke/fast idle lever in the idle
position, lifting up the neutral release
lever enables the control lever to be
moved to the FORWARD or REVERSE
positions.
FAST IDLE
O SHIFT POINT
Range
of Motion
10120
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.