User Manual

10. CONTROL BOXES AND TEMPLATES
SHIFT CABLE
3. Install the shift cable by aligning the cable
groove with the cable guide plate. Then connect
the eye end to the short arm pin using the
washer and
6 mm lock pin. Install the washer on
the lock pin side.
COVER C SCREW(2)
..
I
I
THROTTLE CABLE
CABLE CLAMP SPACER
4. Install the cable clamp spacer and throttle
control cable by aligning the cable groove with
the cable guide plate. Then connect the eye end
to the throttle arm pin using the washer and
6
mm lock pin.
5. Tighten the lock nuts securely.
6. Install the cover
C and tighten the screws
securely.
TORQUE: 2 N-m (0.2 kg-m, 1.4 ft-lb)
I NOTICE I
Ovettightening the mounting screws can
damage or distort the control
box.
REMOTE CONTROL INSTALLATION
After the control cable installation and adjustment,
install the remote control.
REMOTE CONTROL SPACER PLATE
\ \
\
V NUT (3)
WASHER (6)
1. Put the control lever in the neutral position.
2. Hold the remote control at the desired position,
and mark the drill points. Drill three
7 mm (1/4 in) holes at the marked points.
3. Install the control at the selected mounting
location (see page 10-21). Apply one or
two
drops of Hondalock 2 (PIN 08713-0002) to the
threads
of the nuts. Tighten the nuts securely.
CONTROL LEVER FRICTION ADJUSTMENT
The control lever friction can be adjusted by turning
the friction adjuster at the front of the remote
control.
~~, <. FRICTl0;ADJUSTER
\
ASE FRICTION
DECREASE FRICTION
Turning the adjuster clockwise will increase the
control lever friction, turning it counterclockwise will
decrease the control lever friction.
Adjust the friction adjuster
so that a slight amount of
drag is felt. The remote control lever should move
smoothly and freely.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
10124