User Manual

10.
CONTROL
BOXES
AND TEMPLATES
~
7.
8.
HEX HEAD,BOLT /SHIFT ARM ASSEMBLY
Loosen the hex head bolt, and install the shift
arm assembly, while holding it in an inverted
position.
TORQUE:
5-8 N*m (0.5-0.8 kgf-m, 3.6-5.8 Ibf-ft)
Install the throttle shaft on the opposite side to
the original position, with the
two
hex head
bolts.
TORQUE:
5-8 N*m (0.5-0.8 kgf-m, 3.6-5.8 Ibf-ft)
10
mm
(0.4
STOPPER BOLT
9.
Loosen the lock nuts, and reverse the right and
left stopper bolt positions, and secure the bolts
with the
two lock nuts.
TORQUE:
5-8 N*m (0.5-0.8 kgf-m, 3.6-5.8 Ibf-ft)
Do
not allow the stopper bolt to project more
than 10 mm
(0.4
in) from the nut surface.
ClRCLlP
BRAKE
HOOK
10.
Set the brake disk and brake shoe assembly on
the throttle arm asembly, and install the throttle
shaft.
Push in the brake shoe hook until it
fits
into the
hole in the throttle shaft.
11. Install the plain washer and circlip on the throttle
shaft.
12. Make sure the cam plate aligns with the cam
groove (for push-to-open throttle) and the
throttle lever roller.
Make sure the circlip is correctly fitted in place.
13. Install the dwell plate retainer, mounting flange,
back plate, packing and cover according to
page 10-32.
10133
Date
of
Issue: June 2003
0
2001-2003 American Honda
Motor
Co.,
Inc.