User Manual

10. CONTROL BOXES AND TEMPLATES
FLUSH MOUNT REMOTE CONTROL
INSTALLATION (right-hand handle)
This section explains the installation procedure of
the right-hand handle remote control. The left-hand
handle remote control can be installed in the same
manner.
When the mounting plate (hull) is more than
30 mm
(1.18 in), the installation of the remote control box is
impossible.
TEMPLATE
5.
MOUNTI~G SURFACE
1. Attach the drilling template to the remote control
mounting surface using adhesive tape.
2. Drill the installation holes and cut out the center.
3. Pass the remote control wire harness and the
control cables along the route properly.
INNER HOUSING ------Y
4. Remove the screws and remove the back plate
from the inner housing.
CABLE CLAMP
5. Apply marine grease to both the shift and
throttle pins at the end
of each arm.
6. Install the gearshift control cable groove in the
housing clamp groove. Insert the cable end into
the pin at the end of the shift arm and secure
with an E-ring.
7. Insert cable clamp spacer in clamp groove.
THROTTLE
cable ends.
8. Apply marine grease to the throttle cable pin
where
it connects to the throttle arm.
9. Connect the throttle control cable to the throttle
arm, in the same manner as the gearshift
control cable, with an E-ring.
10-36
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.