User Manual
Table Of Contents
1.
COMMON MODEL INFORMATION
METER WIRE CONNECTIONS
Connect wire harnesses properly, as shown in the
meter wiring diagram.
-1
Use Meter Wire Harness
A
and
B
for instruments
ONLY
Do
not
splice or otherwise add any other
electrical appliance
to
the meter harness.
Connect leads and terminals securely. Make sure
terminals are waterproof.
Use 19-gauge (1.25 mm dia.) wire.
Connect the wire harnesses securely. If a terminal
is oxidized or corroded, remove the oxidation or
corrosion with a nonconductive plastic scrub pad or
contact cleaner before reconnecting it.
Make sure all connections are water tight. Use the
Honda Marine Terminal Service Kit
(see page 1-49).
I
Description
I
Part~o.
I
I
07VPZ-001000A
1
Honda Marine Terminal
Service Kit A
Make sure insulators surround their connectors
completely and the ends are not folded up.
Do
not use simple butt connectors. They are not
water/corrosion resistant.
Do
not break the wire harness coverings. If the
covering of a wire is broken, either repair it with
electrician’s tape, or replace it.
Attach unused terminals to the adjacent main
harness with a piece of electrician’s tape
so
the
terminals do not interfere with the surrounding
parts.
After each wire and harness is connected, check for
proper connections by referring to the wiring
diagram. Connect the battery and turn the main
power on to check for proper operation.
Meter Wiring Diagram
The meter wire harness is an independent engine-
control system.
Do not attempt to integrate it with
the boat’s system or other accessories, except for
the instrument light switch.
There are three ways to illuminate the instrument
lights:
Connect a commercially available switch (Teleflex
1A
16970 or equivalent) between the
BIN and
RNV
terminals.
Connect 12V
(+)
from the boat‘s instrument lights
to the
R/W
terminal
OR
connect the BIN and
R/W
terminals together for “lights on” with the engine
switch.
See page 1-53 for standard wire color table.
HOUR METER
SPEEDOMETER VOLTMETER
I..
METER WIRE HARNESS
A
PIN 32540ZV5-910
‘See
page
5-15
for
BF40NBF50A
trim meter connections.
Date
of
Issue: June 2003
0
2001-2003 American Honda Motor
Co.,
Inc.
1-40