User Manual

1. COMMON MODEL INFORMATION
TERMINAL SERVICE KIT A
REFERENCE GUIDE
SPECIAL CONNECTORS
PIN TOOL F
w-1 here, and push the I
lock out.
Hold pin tool firmly by the handle with the pin tool in
the down position.
Hold connector housing with attachment tab on the
top facing toward you. Place the tip
of the pin tool
toward the front of the release tab on the top of the
terminal top.
While pressure is applied to the release tab with the
pin tool, pull the connector housing from the
terminal.
PINTOOLF
1 / (PIN 07JAZ-002060A)
CONNECTORS WITH A SECONDARY LOCK
Male
out of the connector
with needle-nose
Terminal Half
n
Female Terminal Half
(PIN 07JAZ-O02060A),
Remove the secondary lock.
PIN TOOL F
1. Push the wire into the connector to relieve the
tension on the primary lock.
2. Insert the tool at the middle of the terminal.
3. Push down on the tool to lift up on the primary
lock.
4. Pull the connector out of the terminal. female).
Remove the terminal (same procedure for male and
1. Push the wire into the connector to relieve the
tension on the primary lock.
2. Insert the tool under the terminal and lift up.
3. Pull the terminal out of the connector.
1150
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.