User Manual

2. BF8DIBF9.9D
TRANSOM DRILL FIXTURE
/
bB B@
Use the upper and lower “B” holes.
1. Mark four center marks for the bolt holes on the
transom board
(two marks on either side of the
outboard motor installation lines).
The upper bolt holes should be more than
33 mm (1.3 in) from the top of the transom.
The lower bolt holes should allow the mounting
bolts to contact the upper end of the stern
bracket.
4 90’
2. Drill four holes with an 11 mm drill bit.
Small Bracket (Types SH, SHS, LH, LHS)
192 mm (7.6 in)
r-
8.2 mm 2 (80.3 in)
I
(3.7 in)
P 95mm
TRANSOM DRILL FIXTURE
I
BB
0
D
C
I
Use the upper “A” holes.
Drill two holes with a “Q drill bit.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
217