User Manual

3. BFlSDIBF20D
Shaft
Length
INSTALLATION HEIGHT
RECOM M EN DATl ON S
Outboard Workable Boat
Transom Height Transom Height
TRANSOM DRILL FIXTURE
TRANSOM DRILLING
See also “USING THE TRANSOM MOUNT DRILL
FIXTURE” on page 1-23.
Description I PartNo. I
I
I Transom Mount Drill Fixture I 07MPZ-ZV3010C I
The BF15D and BF20D outboards motors are
designed to be installed on a boat transom with the
following transom board thickness:
I
Boat Transom Board Thickness--- -1
35 - 57 mm (1.3 - 2.2 in)
1. Set the outboard motor onto the boat transom
and verify the installation height is correct.
,. 244mm,;.6in) ,
TRANSOM BOARD TOP
EF
2=
E;
’ 128 mm (5.0 in)‘
BB
0
I
Use the upper and lower “B” holes.
2. Mark four center marks for the bolt holes on the
transom board
(two marks on either side of the
outboard motor installation lines).
The upper bolt holes should be more than
33 mm (1.3 in) from the top of the transom.
The lower bolt holes should allow the mounting
bolts to contact the upper end of the stern
bracket.
4 90”
3. Drill four holes with an 11 mm drill bit.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
316