User Manual
Table Of Contents
3.
BFISDIBFZOD
1
,
LOaPLATE(2)
CONTROL
\
SHIFT
CONTR~L
CABLE
4.
Shift the outboard into forward gear by moving
the shift link arm forward while turning the
propeller.
5.
Coat the pivots with marine grease.
6.
Set the remote control lever full forward and
adjust the shift pivot to be a slip fit in the shift
link arm. Slide the lock plate
down
to secure the
Divot.
a.
Operate the remote control and check to see
that:
When the remote is at full throttle (WOT), the
throttle is within
1
mm of the stop.
When the remote is at full throttle (WOT), the
shift linkage is in the forward detent.
When the remote is in neutral, the throttle is
against the idle stop screw.
When the remote is
in
neutral, the shift
linkage is in the neutral detent.
When the remote is in reverse, the shift
linkage is in the reverse detent.
(Turn the prop while shifting gears.)
7.
With the remote control lever still full forward,
hold the throttle remote arm against the full
throttle stop and adjust the throttle pivot to be a
slip
fit
in the throttle remote arm. Slide the lock
plate
up
to secure the pivot.
Date
of
Issue: June 2003
0
2001-2003 American
Honda
Motor
Co.,
Inc.
311
2