User Manual

1. COMMON MODEL INFORMATION
DUAL OUTBOARD INSTALLATION
BF200AI225A, BF115A/130A, BF75AI90A
432 mm 432 mm
(17 in) (17 in)
minimum minimum
u!u
U
660 mm (26 in)
minimum
Dual outboards must be installed so the outboard
center-to-center distance is a minimum of
660 mm
(26 in). The transom board should still have a
minimum extra space of
432 mm (17 in). Be sure
the boat is well-balanced.
Mount the counter-rotation outboard on the port
side.
B F40AIB F50A
432 mm 432 mm
(17 in) (17 in)
minimum
! minimum
I I- I ! I
U
610 mm (24 in)
minimum
Dual outboards must be installed so the outboard
center-to-center distance is a minimum of
610 mm
(24 in). The transom board should still have a
minimum extra space of
432 mm (17 in). Be sure
the boat is well-balanced.
TRANSOM CENTER LINE
Measure across the transom to determine the
transom center line and draw a vertical line. On a
“V bottom boat, the vertical line should pass
through the keel.
Use a pencil and tape measure to locate center line.
MARK FIRST
I.
2.
Put one end of the tape measure on a chine and
place the other end on the upper edge of the
transom, somewhere past the “visual” center.
Place a mark on the transom and record the
distance measured.
MARK SECOND
Measure the same distance from the opposite
chine and make a mark.
1121
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.