User Manual

4.
BF25NBF30A
WASHER
LOCK NUT
PIVOT SHAFT
\
/
CONTROL CABLE
(marine grease)
6.
Thread the lock nuts all the way on the control
cables. Thread the pivots shafts onto the control
cables. Apply marine grease as shown.
7.
Verify that the shift arm on the outboard motor is
in the neutral position, or that the control lever at
the remote control
box
is in the neutral position.
/
SHAFT
OCK NUT
WASHERS
I
DO NOT
FORGET
TO
INSTALL.]
SHIFT
CONTROL
6
mm
LOCK PIN
THROTTLE CONTROL CABLE
8.
Connect the control cables to the shift arm and
throttle arm using the
6
rnrn washers and lock
pins as shown.
Use the
6
mrn
washers on both
sides
of
the arm.
Do
not forget to install the
washers.
If
the hole in the shift arm and the
pivot shaft do not align, turn the pivot shafts in
or out to align the pivot pin with the shift or
throttle arm holes as necessary. Turn the lock
nut up to the pivot shaft, then tighten the lock
nuts securely.
SEPARATE TOP
edgelside
against
painted
surface.
n
I
11
+
BOAT
u
I
I
9.
Install the separate top cover and tighten the
bolts securely.
Install the washers with the rounded edgehide
against the painted surface to prevent paint
damage and corrosion.
Date
of
Issue: June 2003
0
2001-2003 American Honda Motor
Co.,
Inc.
411
2