User Manual

5. BF40NBF50A
CONTROL CABLE LENGTH
ADJUSTMENT
THROTTLE CONTROL CABLE
1. Put the remote control lever in the neutral
position.
2. Disconnect the throttle control cable from the
throttle arm.
PEN
CARBURETOR
THROTTLE
PIVOT
\ STOPPER
LEVER
THROTTLE ROD
3.
4.
Move the throttle arm to the fully-open position
until it touches the stopper, and verify that the
carburetor throttle lever touches the stopper in
the fully-open position.
If not, loosen the lock nut, disconnect the
throttle rod from the throttle cam, and adjust the
throttle rod length by turning the linkage pivot.
LOCK NUT THROTTLE CAM
I
LINKAGE PIVOT
5.
6.
THROT+LE ROD
After the adjustment, connect the throttle rod to
the throttle cam and tighten the lock nut
securely.
Reconnect the throttle control cable to the
throttle arm.
INDEX MARKS
PIVOT ROLLER
I
THROTTLE CAM
7. Verify that the center of the pivot roller aligns
with the index marks on the throttle cam.
8. If not, loosen the throttle control cable lock nut,
disconnect the throttle control cable and turn the
pivot shaft until adjustment is correct.
9. After the adjustment, reconnect the throttle
control cable and tighten the lock nut securely.
10. Move the remote control lever and verify the
following:
The control lever moves smoothly into all
positions.
The carburetor throttle lever moves smoothly
without binding from the fully-opened to the
fully-closed position.
SHIFT CONTROL CABLE
1. Move the remote control lever to the reverse
position.
2. Disconnect the shift control cable from the shift
arm.
CLICK ROLLER
\
' SHIFT LINK B
3. Verify the click roller is in the center of the
groove on the shift link
B at the (R) mark.
511 3
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.