User Manual

5. BF40NBF50A
DETENT ROLLER
\A
/-
SHIFT LINK B
4. If not, loosen the lock nut and adjusting nut
connecting shift rod
A to shift rod B.
5. Disconnect shift rod A from shift rod B by
backing
off the adjusting nut. Back off the
adjusting nut until it is approximately
3 mm
above the top of shift rod
B.
6. Turn the lock nut on shift rod B to obtain 0.3 inch
(8 mm) between the lock nut and the top of shift
rod B as shown.
7. Thread the adjusting nut onto shift rod B until
the adjusting nut comes in contact with the lock
nut. When the adjusting nut contacts the lock
nut, tighten the lock nut and adjusting nut
together.
8. Reconnect the shift control cable to the shift
arm.
9. Put the remote control lever in the neutral
position.
10. Verify the detent roller sits in the N groove of the
shift link
B.
11. If not, loosen the shift control cable lock nut,
disconnect the shift control cable and turn the
pivot shaft until the adjustment
is correct.
12. After the adjustment, reconnect the shift control
cable and tighten the lock nut securely.
13. Verify the remote control lever moves smoothly
into all positions.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
511 4