User Manual

1. COMMON MODEL INFORMATION
Description
outboard is the vertical distance from the horizontal
contact surface of the transom bracket to the anti-
ventilation plate.
If the outboard installation height cannot be
achieved, adjust boat transom height.
TRANSOM HEIGHT ADJUSTMENT
If the transom is too low or too high, or needs to be
modified to accommodate the width of the outboard
motor(s), contact the boat manufacturer and follow
their recommendations for corrective action.
If mounting
two outboard motors, be sure the
installation height is identical for both.
Some boat manufacturers June require different
mounting heights. Consult your boat manufacturer
for specifics on your boat.
Part No.
USING THE TRANSOM MOUNT
DRILL FIXTURE
Verify no damage will occur when the motor
mounting holes are drilled. Look for any structural
impediments such as bulkheads, braces, fuel cells,
bilge pumps, or floor sections before drilling.
Ensure there
is adequate space for the bolt, washer
and transom support plates (if applicable) to bear
on a flat surface.
B
0
co Dm
I Transom Mount Drill Fixture I 07MPZ-ZV301OC I
See TRANSOM DRILLING section in applicable
model-family chapter for additional information
regarding use of the transom mount drill fixture.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
1-23