User Manual

5. BF40NBF50A
COMMON PROCEDURES
Always make sure all bullet connector boots are properly seated.
Four Wire Connector
A four wire blue connector was used on all models prior to the BF40A3 BF50A3 and a four wire black
connector is used on all BF40A3
BF50A3 models. Refer to page 5-20 for connector location.
Combinations 1, la, 3b
1. Use a small piece of safety wire or terminal pin tool F to remove the rubber plug.
RUBBER PLUG
Remove and discard.
+-
I I
2. Depending on the combination, insert the optional light greedblack 20 inch wire or the VCM wire spade
terminal into connector.
I , - --- ------ I
Make sure the wire seal is pushed all the way into the connector.
Lightly pull on the wire to make sure the terminal is locked in place.
Date of Issue: June 2003
0 2001-2003 American Honda Motor Co., Inc.
511 8