- Honda Generator Owner's Manual

12. INSTALLATION OF OPTIONAL PARTS

Remote control kit

The generator may be adapted for remote control operation by use of an

optional kit.

1. Unscrew the two 6 x 10 mm flange bolts and 6 x 8 mm screws attaching

the control panel. Remove the control panel.

6 x 10 mm FLANGE BOLTS

2. Position the relay box on the back of the control panel with the studs

inserted through the holes in the relay box flange. Install a 4 mm nut and

lock washer on each stud and tighten securely.

3. Remove the 6-P coupler with a jumper wire from the wire harness female

coupler. Connect the relay box 6-P male coupler to the wire harness female

coupler.

4. Insert the relay box 6-P female coupler in the hole in the sub panel below

the control panel and install with the two self-tapping screws and coupler

holder.

4 x 10 mm SELF-

TAPPING SCREWS

CONTROL

COUPLER HOLDER

HOLE IN SUB PANEL

4 mm’NUT