Outboard Motor User Manual
Table Of Contents
- COVER
- INTRODUCTION
- CONTENTS
- OUTBOARD MOTOR SAFETY
- CONTROLS AND FEATURES
- CONTROL AND FEATURE ID CODES
- COMPONENT AND CONTROL LOCATIONS
- LHT TYPE (TILLER HANDLE)
- LRT AND XRT TYPES (REMOTE CONTROL)
- REMOTE CONTROL BOX (SIDE-MOUNT CONTROL TYPE) (OPTIONAL EQUIPMENT)
- PORTABLE FUEL TANK (OPTIONAL EQUIPMENT)
- TRIM METER (OPTIONAL EQUIPMENT)
- TACHOMETER (OPTIONAL EQUIPMENT)
- RUDDER METER
- TROLLING CONTROL SWITCH PANEL
- DIGITAL SPEEDOMETER (OPTIONAL EQUIPMENT)
- DIGITAL TACHOMETER (OPTIONAL EQUIPMENT)
- CONTROLS
- BEFORE OPERATION
- OPERATION
- SAFE OPERATING PRECAUTIONS
- BREAK-IN PROCEDURE
- PORTABLE FUEL TANK (OPTIONAL EQUIPMENT)
- FUEL HOSE CONNECTIONS
- FUEL PRIMING
- INFREQUENT OR OCCASIONAL USE
- STARTING THE ENGINE
- EMERGENCY STARTING
- STOPPING THE ENGINE
- GEARSHIFT AND THROTTLE OPERATION
- STEERING
- CRUISING
- TRIM TAB
- SHALLOW WATER OPERATION
- MOORING, BEACHING, LAUNCHING
- SERVICING YOUR OUTBOARD MOTOR
- CLEANING AND FLUSHING
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- INDEX
×
×
×
45
Tiller Handle Height/Angle
Adjustment (LHT type)
BEFORE OPERATION
HANDLE ANGLE: 13°
Reference point
HEIGHT ADJUSTMENT
BLOCK
HANDLE ANGLE: 13°
HANDLE ANGLE: 21°
HANDLE ANGLE: 7°
Install the height adjustment block
so that the selected angle of the
tiller handle is in this position.
HANDLE ANGLE: 7°
HANDLE ANGLE:
21°
828mm
FLANGE BOLT
HEIGHT
11.5 in
(293 mm)
14.0 in
(355 mm)
17.0 in
(433 mm)
The tiller handle height and angle can
be adjusted to three positions by
changing the installation direction of
the height adjustment block. Select a
suitable height and angle for the
operator and secure the block.
Raise the tiller handle and remove
the 8 28 mm flange bolt and the
height adjustment block.
Pull down the tiller handle.
Determine the height adjustment
block installation direction and
secure the block with the 8 28
mm flange bolt.
2.
1.
11/03/09 17:40:55 31ZZ3610_046