Outboard Motor User Manual

−
−
Exposed moving parts can
cause injury.
Do not operate the
outboard motor without
the engine cover.
Use extreme care when
installing the engine
cover.
57
OPERATION
KNOT
ALTERNATOR
PULLEY
DDiirreeccttiioonn
ttoo ppuullll
EMERGENCY STARTER ROPE
EMERGENCY STARTER ROPE
TAKING CARE OF
UNEXPECTED PROBLEMS
Set the controls the same as for
normal starting (p. ,
).
Turn the ignition switch key to the
ON position.
Set the alternator pulley so the
cutouts are on the right and left
sides of the alternator pulley as
shown. Hook the knot at the end of
the starter rope (accessory) against
a cutout in the alternator pulley,
and wind the starter rope one and a
half turns clockwise along the
groove in the alternator pulley.
Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If necessary, rewind the rope and
pull again. If the engine does not
start after several attempts, refer to
from p. .
5.
6.
4.
53 55
50 51
105
11/03/09 17:43:03 31ZZ3610_058