Outboard Motor User Manual
Table Of Contents
- COVER
- INTRODUCTION
- CONTENTS
- OUTBOARD MOTOR SAFETY
- CONTROLS AND FEATURES
- CONTROL AND FEATURE ID CODES
- COMPONENT AND CONTROL LOCATIONS
- LHT TYPE (TILLER HANDLE)
- LRT AND XRT TYPES (REMOTE CONTROL)
- REMOTE CONTROL BOX (SIDE-MOUNT CONTROL TYPE) (OPTIONAL EQUIPMENT)
- PORTABLE FUEL TANK (OPTIONAL EQUIPMENT)
- TRIM METER (OPTIONAL EQUIPMENT)
- TACHOMETER (OPTIONAL EQUIPMENT)
- RUDDER METER
- TROLLING CONTROL SWITCH PANEL
- DIGITAL SPEEDOMETER (OPTIONAL EQUIPMENT)
- DIGITAL TACHOMETER (OPTIONAL EQUIPMENT)
- CONTROLS
- BEFORE OPERATION
- OPERATION
- SAFE OPERATING PRECAUTIONS
- BREAK-IN PROCEDURE
- PORTABLE FUEL TANK (OPTIONAL EQUIPMENT)
- FUEL HOSE CONNECTIONS
- FUEL PRIMING
- INFREQUENT OR OCCASIONAL USE
- STARTING THE ENGINE
- EMERGENCY STARTING
- STOPPING THE ENGINE
- GEARSHIFT AND THROTTLE OPERATION
- STEERING
- CRUISING
- TRIM TAB
- SHALLOW WATER OPERATION
- MOORING, BEACHING, LAUNCHING
- SERVICING YOUR OUTBOARD MOTOR
- CLEANING AND FLUSHING
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- INDEX
91
SERVICING YOUR OUTBOARD MOTOR
FUEL FILTER
(inside strainer cup)
FUEL FILTER BRACKET
FUEL
HOSES
SUSPENSION STRAP
HOSE CLIPS
(commercially available)
FUEL FILTER
ASSEMBLY
CLAMPS
FUEL FILTER
(inside strainer cup)
FUEL HOSES
SUSPENSION
STRAP
Inspect the filter for water and/or
sediment accumulation.
If water and/or sediment are
present, clean the strainer cup and
filter or replace the filter as
described in the following steps.
Always replace the filter at the
scheduled replacement interval (p.
).
Remove the suspension strap from
the fuel filter bracket, and then
remove the strap from the fuel
filter assembly.
Place commercially available hose
clips on the fuel hoses on each side
of the filter to prevent fuel leakage
when the fuel hoses are
disconnected.
Disconnect the fuel tubes from the
fuel filter assembly.
2. 3.
4.
5.
76
11/03/09 17:49:06 31ZZ3610_092