Outboard Motor User Manual
Table Of Contents
- COVER
- INTRODUCTION
- CONTENTS
- OUTBOARD MOTOR SAFETY
- CONTROLS AND FEATURES
- CONTROL AND FEATURE ID CODES
- COMPONENT AND CONTROL LOCATIONS
- LHT TYPE (TILLER HANDLE)
- LRT AND XRT TYPES (REMOTE CONTROL)
- REMOTE CONTROL BOX (SIDE-MOUNT CONTROL TYPE) (OPTIONAL EQUIPMENT)
- PORTABLE FUEL TANK (OPTIONAL EQUIPMENT)
- TRIM METER (OPTIONAL EQUIPMENT)
- TACHOMETER (OPTIONAL EQUIPMENT)
- RUDDER METER
- TROLLING CONTROL SWITCH PANEL
- DIGITAL SPEEDOMETER (OPTIONAL EQUIPMENT)
- DIGITAL TACHOMETER (OPTIONAL EQUIPMENT)
- CONTROLS
- BEFORE OPERATION
- OPERATION
- SAFE OPERATING PRECAUTIONS
- BREAK-IN PROCEDURE
- PORTABLE FUEL TANK (OPTIONAL EQUIPMENT)
- FUEL HOSE CONNECTIONS
- FUEL PRIMING
- INFREQUENT OR OCCASIONAL USE
- STARTING THE ENGINE
- EMERGENCY STARTING
- STOPPING THE ENGINE
- GEARSHIFT AND THROTTLE OPERATION
- STEERING
- CRUISING
- TRIM TAB
- SHALLOW WATER OPERATION
- MOORING, BEACHING, LAUNCHING
- SERVICING YOUR OUTBOARD MOTOR
- CLEANING AND FLUSHING
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- INDEX
94
Anode Replacement
SERVICING YOUR OUTBOARD MOTOR
ANODE
(stern bracket)
ANODE
(each side)
5 mm SCREWS (4)
FUEL TANK
FILTER JOINT
(Fuel Hose
Connector)
FUEL TANK
FILLER
CONNECTOR
GASKET
Fuel Tank Filter
Painting or coating the anodes will
def eat their purpose and will lead to
rust and corrosion damage to the
outboard motor. The anodes must be
exposed to the water in order to
protect the outboard motor.
The anodes are located on each side
of the gear case and on the stern
bracket. They are made of a
sacrificial material that helps to
protect the outboard motor from
corrosion.
Replace the anodes when they have
been reduced to about one third their
original size, or if they are crumbling.
Remove the four 5 mm screws
using a flat screwdriver, then
remove the fuel hose connector
and fuel tank filter from the tank.
Reinstall the filter and hose
connector in the fuel tank. Tighten
the four 5 mm screws securely.
Clean the filter in nonflammable
solvent. Inspect the fuel tank filter
and the connector gasket. Replace
them if damaged.
1.
2.
3.
11/03/09 17:49:41 31ZZ3610_095