Owner's Manual Instruction Manual

320
Features
Compass
*
When you turn the ignition switch to ON
(w
, the compass self-calibrates, and the
compass display appears.
Compass Calibration
If the compass indicates the wrong direction, or the compass display blinks, you
need to manually calibrate the system.
1. Turn
the ignition switch to ON
(w
.
2. Press and hold the SETUP button until the
display shows the compass setting menu
list.
3. Ro
tate to select Calibration, then press
.
4. When the
display changes to Start
Calibration, press .
5. Drive the vehicle slowly in two circles.
u T
he compass starts to show a direction
after the calibration. The CAL indicator
goes off.
1Compass
*
Compass calibration can be affected under the
following conditions:
• Driving near power lines or stations
• Crossing a bridge
• Passing a large vehicle, or driving near a large
object that can cause a magnetic disturbance
• When accessories such as antennas and roof racks
are mounted by magnets
On some models, the Compass Calibration screen is
displayed but Calibration and Zone Adjust will not
respond if selected.
1Compass Calibration
Calibrate the compass in an open area.
While setting the compass:
• The RETURN button returns to the previous screen.
• The SETUP button cancels the setting mode.
* Not available on all models