Owner manual
16
5718100S
Stopping the Engine
1. Push the command button on the transmitter for
1 second or less, then push the stop button within 2
seconds.
2. The transmitter emits a short beep and sends a
signal to stop the engine. When the engine stops,
the OFF indicator is shown on the display.
NOTE
• When the RF signal from the
transmitter does not carry to
the receiver, the transmitter
emits three short buzzer
sounds but no indicator is
shown on the display.
• The engine cannot be stopped
with the transmitter when it was
started using the ignition key.
• In some cases the remote transmission range can be
longer than the reception range. Therefore the engine
can be started/stopped, and the remote status may
not be displayed.
7336070T
ENGINE-OFF
INDICATOR
STOP
BUTTON
COMMAND
BUTTON