Owner's Manual

Exposed moving parts can
cause injury.
Do not operate the
outboard motor without
the engine cover.
Use extreme care when
installing the engine
cover.
43
OPERATION
FLYWHEEL
EMERGENCY
STARTER
ROPE
KNOT
TAKING CARE OF
UNEXPECTED PROBLEMS,
Set the knotted end of the
emergency starter rope in the notch
in the flywheel. Wind the rope
counterclockwise around the
flywheel, as shown.
Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If the fast idle control(s) was used
to start the engine, return the
control(s) to the normal operating
position as the engine warms up.
During the warm-up period, check
the oil pressure indicator (p. ),
overheat indicator (p. ), and
cooling system indicator (p. ).
Install the engine cover (p. ),
and lock it in place by latching the
engine cover latches.
If necessary, rewind the rope and
pull again. If the engine does not
start after several attempts, refer to
p. .
5.4.
6.
7.
27
29
24
84
28
04/03/15 11:02:39 31ZW3600_044